How do I make my alarm vibrate

Mini Vibrating Alarm Clock

Dual-screen upgraded timer design

Time/timing setting

(1) Clock, set on Wednesday
Set the clock mode for about 3 seconds, the hour flashes, press the UP button to increase the value and press ST / SP to decrease the value. Press the SET button to flash, press the UP button to increase, press ST / SP to decrease. Press the SET button to blink in seconds, and press the UP or ST / SP button to reset the seconds to zero. Press the SET button, it flashes on Wednesday, presses the UP button to increase and ST / SP to decrease. Press SET to confirm.

(2) Positive timing
In the timekeeping mode, press the ST / SP key to start timing, press the ST / SP key to pause, and then press the ST / SP key to continue the positive timing. When the positive timing is paused, press the UP key to return to zero. You can press the ST / SP key to restart the timing.

(3) Countdown
Keep the UP button pressed for about 3 seconds, the hour flashes, press the UP button to increase and press ST / SP to decrease. Press the SET key to switch to minutes flashing, and set the hours and minutes in sequence. Press SET to confirm. Press the ST / SP button to start the countdown, press the ST / SP button to pause the countdown, and then press the ST / SP button to continue the countdown. Press the UP button to quickly reset to the set countdown timer when the countdown is paused. The countdown is paused and the SETUP key is reset to zero. When the countdown ends, it starts counting and prompts for 30 seconds. You can press the ST / SP key to end the prompt and reset to the set countdown time

Loop countdown:

(1) 2 sets of cycle alternate timing
Timing interface (at least 25-5 minutes), hold down the SET button for about 3 seconds, the uplink hour flashes, press the UP button to increase, press ST / SP to decrease. Press the SET button to switch to the minute flashing, set the up, down hours, minutes, seconds, value and prompt time in sequence, press the SET button to confirm, press the ST / SP button to start the cycle countdown. Press ST / SP key again to pause, press UP key to pause to reset to set time. (When the number of timing cycles is set to 0, the number of times is counted up. When the number of timing cycles is set, the countdown is set by the set number of cycles. When the countdown reaches 0, the timing stops

(2) Single group cycle timing
The counting mode only sets any-group timing time, prompt mode and prompt time. Another-set the group time to 0 to count down in a single cycle.

Leave a Reply

Your email address will not be published. Required fields are marked *

Share via
Copy link
Powered by Social Snap