how to turn on sharp retro alarm clock usb port

how to turn on sharp retro alarm clock usb port

Thank you for coming to my website. Your clocks and watches are designed and manufactured with great care. Please read these instructions and store them in a safe place for future reference.

FEATURES:

  1. Large 1.4″ LED Display
  2. Dual Alarm
  3. High or Low Display Brightness
  4. 9 Minute Snooze
  5. 9V Battery Back up (Batery Not Included)
  6. your browser is not showing pictures of this clock
  7. POWER SUPPLY
  8. Begin by plugging in the power cord into a standard household outlet.
  9. The display will flash indicating it needs to be set.

SETTING THE TIME

  1. Press and hold the TIME button down to activate time setting.
  2. White holding down the TIME button, press the HOUR button to advance to the correct hour.
  3. The PM indicator will light when the hour is advanced into the PM time.
  4. While holding down the TIME button, press the MINUTE button to advance to the correct minute.
  5. Release the TIME button when the correct time is shown on the display.

SETTING THE ALARM 1/2

  1. Slide the ALARM 1/2/DUAL slide switch to ALARM 1/2 position, then press and hold the ALARM button to activate alarm 1/2 setting.
  2. The ALARM 1/2 Indicator will light when the alarm 1/2 setting is activated.
  3. While the ALARM 1/2/DUAL slide switch is on the ALARM 1/2 position and holding down the ALARM button, press the HOUR button to advance to the correct hour.
  4. The PM Indicator will light when the hour is advanced into the PM time.
  5. While the ALARM 1/2/DUAL slide switch is on the ALARM 1/2 position and holding down the ALARM button, press, the MINUTE button to advance to the correct minute.
  6. Release the ALARM button when the correct alarm 1/2 time is shown on the display.

USING THE ALARM

  1. Slide the ALARM ON/OFF switch to the ON position, then slide the ALARM 1/2/DUAL slide switch to choose using alarm 1, alarm 2, or dual alarm.
  2. The ALARM 1 indicator dot and ALARM2 Indicator dot will be lit according to your choice.
  3. The alarm will sound at the preset time.
  4. Slide the ALARM ON/OFF switch to the OFF position to deactivate the alarm.
  5. The Alarm Indicator dot will no longer be visible.

USING THE SNOOZE

  1. Pressing the SNOOZE/DIMMER button when the wake-up alarm is sounding will cause the alarm to stop and the alarm will sound again in nine minutes.
  2. This will happen each time when the SNOOZE/DIMMER button is pressed.

USING THE DIMMER

  1. While the alarm is not sounding, press the SNOOZE/DIMMER button to change the HIGH or LOW seting to control the brightness of the clock display.
  2. Note: The default is HIGH setting.

BATTERY BACK UP

  1. Turn the clock over and insert a 9V battery as indicated to provide battery back up.
  2. The battery will hold the ALARM and TIME settings until power is restored.
  3. There will be no display under battery power and the ALARM will sound at the correct time.
  4. If there is no battery and the power is interrupted, the display will flash 12:00 and the ALARM and the TIME will need to be reset.

CARE OF YOUR CLOCK

  1. Replace the back up battery annually, or store the clock without a battery when not in use.
  2. A soft cloth or a paper towel may be used to clean your clock.
  3. Do not use any corrosive cleaner or chemical solutions on the clock.
  4. Keep the clock clean and dry to avoid any problems.

Leave a Reply

Your email address will not be published.

Share via
Copy link
Powered by Social Snap